diacom adapter

[Ken Kelly]

I thought you also had to change the resistor value value on
the Diagnostic enable lead B to force the ECM into High
speed data mode.

		Ken

TBK wrote:
> 
> It switches M and E, the two serial outputs. E is traditionally the 160 baud
> serial out, and M is the 8192 serial out. Some cars are swapped (Vettes). D
> is the 160 CE lamp output.
> 
> TK
> -----Original Message-----
> From: wayne johnson <flying.monkey at juno.com>
> To: diy_efi at efi332.eng.ohio-state.edu <diy_efi at efi332.eng.ohio-state.edu>
> Date: Monday, June 29, 1998 3:18 PM
> Subject: Re: diacom adapter
> 
> >Thanks
> >
> > Cheers,
> > Wayne Johnson
> >
> >>All it is is a double DIN connector (M & F) that, from what I
> >>understand, just switches the pinouts between the ALDL connector and
> >>the
> >>Diacom cable.
> >
> >
> >_____________________________________________________________________
> >You don't need to buy Internet access to use free Internet e-mail.
> >Get completely free e-mail from Juno at http://www.juno.com
> >Or call Juno at (800) 654-JUNO [654-5866]
> >