GM tbi

[Clare Snyder]

Shannen Durphey wrote:
> 
> Steven Gorkowski wrote:
> 
> > I have a Rochester Products T.B.I. unit it has stamped DESIGN UNIT and a
> > number 17090003  next to a GM logo . It looks like a standard throtle
> > body but has a solinoid that when 12v is applyed the throtle plates go
> > to wide open. The unit had a tag that said it is for a 350 ci .Do you
> > have any information on these units?
> 
>   Hmmm.  Curious description.  Does the solenoid look like it's factory
> installed?  Is this something someone might have modified?  Some of the 454
> units had a vacuum controlled throttle stop which would keep throttle plates
> from closing too quickly when shifting (manual trans).  Maybe solenoid was
> installed there?  Or maybe it's just an idle speed control which is
> mis-adjusted?  Anyway, I'll take a look and see if that number is good or
> crosses over to something else tomorrow.
> 
> Shannen
Mabee something put together for a dragster - to pop the throttle open
according to some kind of timer?
-- 
                               _/\_
                       --|-----([])-----|--
                         S    0/  \0    B
         Alls well that ends well!! www.snyder.on.ca is back
                  E-Mail service is back to normal
                  To avoid bouncing E-Mail messages
                    Reply to Clare at snyder.on.ca
                                OR
Remove the R from clsnyder in my E-Mail Address to reply. Stop the
spammers!!!
It's hard to soar like an eagle when your stuck with a bunch of
Turkeys!!!