return line to gas tank
mrvette
mrvette at bellsouth.net
Thu Oct 22 23:24:23 GMT 1998
thanks for the tips, Greg, I going to try this, when I get a chance,..it's a
high priority....but not THAT hi....GENE
Greg Hermann wrote:
>
> ..any idea how thick
> >these things are?...and what the fuel flow rate is through a 3/8" od line
> >at ~40
> >psi is? if the math works out Im fairly certain there is a solution to
> >mounting it....
>
> WAG = 16 GA (about .060") tank thickness. Run your fuel lines in 1/2" (AN8)
> to have some reserve. Fuel suction line from main tank to the LP pump in
> 5/8 or 3/4" (AN 10 or 12) line. Go to a true INDUSTRIAL piping supply house
> and buy a FORGED steel fitting(s) called a threadolet (with the correct
> size(s) female pipe thread in one end). WELD it (or them) to wherever you
> want it (them) on the tank (recommend MIG (wirefeed)). Then drill the
> hole(s) into the tank through the center of the fitting(s) using a nipple
> screwed into the threadolet as a drill bushing (guide). Orient tank
> vertically, with original valve outlet straight down. Take suction from
> this outlet to feed HP pump. If you wanna get really carried away, BG Fuel
> Systems sells insanely rugged fuel accumulators (they have an O-ringed
> piston inside, with an adjustable gas charge on the other side of the
> piston from the fuel). If you use one of them (either on the HP or LP side
> of system), orient it with the outlet UP, so you do not trap vapor in the
> accumulator(s). An accumulator on the LP side is the biggest aid, but both
> sides do some good.
> >
> When done, go have fun!!
>
> Regards, Greg
--
____________
Fun under the sun in //~~~~~~~~~~~~\\
Jacksonville, Fl. :-))) //______________\\
/~~~---~ | | ~---~~~\
/| /______\____/______\ |\
(( | / | | \ | ))
Mako 'Vettes | \============================/ |
Shift better with |\ \\[ ] |mrvette| [ ]// /|
Automatics | \/+========================+\/ |
|~==============================~|
|_____| |_____|
-------------------------------------------------------------------
More information about the Diy_efi
mailing list