Won't go into learn
Bruce Plecan
nacelp at bright.net
Sun Apr 18 02:25:24 GMT 1999
----- Original Message -----
From: David A. Cooley <n5xmt at bellsouth.net>
To: <diy_efi at efi332.eng.ohio-state.edu>
Sent: Saturday, April 17, 1999 9:27 PM
Subject: Re: Won't go into learn
Don't know about the chip, but the truck had been running OK.
All the values seem valid, and move some, commanded AFR at WOT seems
resonable (12:1). Just doesn't pull right.
Bruce
> At 09:08 PM 4/17/99 -0400, you wrote:
> >I've got a Diacom run of a Syclone that isn't running right. Everything
> >looks good, but the odd thing is that learn stays off... Is this a clue
> >that it's using a default value for something?.
>
> That's possible... Is it running an aftermarket chip?
> If so, wonder if they disabled learn mode... usually if it substitutes a
> default it also throws a code.
> ===========================================================
> David Cooley N5XMT Internet: N5XMT at bellsouth.net
> Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
> Sponges grow in the ocean... Wonder how deep it would be if they
didn't?!
> ===========================================================
>
More information about the Diy_efi
mailing list