carbide cylinder bore conversion (Bore Tech)
David A. Cooley
n5xmt at bellsouth.net
Sun Jan 10 20:45:47 GMT 1999
At 01:33 PM 1/10/99 -0700, you wrote:
>
>Not really so when dealing with an 8 u inch polished finish. If the bores
>are the same diameter (within a couple of ten thousandths, and all
>straight, no prob. I thought about lapping each set of rings to its own
>hole, but decided that the extra block clean-up was a nightmare (not to
>mention stray lapping compound) waiting to happen. (Lapping compound in
>this case would be more like jewelers' rouge than what you are used to
>thinking of for lapping valves. WAY finer.) Lots of serious HP boat motors
>are pre-seated this way. It works. Also saves a LOT of break in debris from
>floating around insside the engine.
>
Just out of curiosity, what's the boretech treatment cost?
===========================================================
David Cooley N5XMT Internet: N5XMT at bellsouth.net
Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
I am Pentium of Borg...division is futile...you will be approximated.
===========================================================
More information about the Diy_efi
mailing list