BMFC, Tiiming, and Coatings

[Bruce Plecan]

----- Original Message -----
From: Tom Sharpe <twsharpe at mtco.com>
To: <diy_efi at efi332.eng.ohio-state.edu>
Sent: Saturday, May 15, 1999 6:53 PM
Subject: Re: BMFC, Tiiming, and Coatings

Thanks,
Bruce


> Just seat of the pants measurements... medium hot 406 sbc, electric fan
(on @
> 200), griffin radiator, 7 qt pan, with mild overheating problems... Idle
in
> traffic H2O @ 220-235, now 195-200,  Oil @ 230-250+ now 200. At 75 mph
cruse,
> lite load, H2O was 190-195, now 180, (thermostat), oil was 200-210 now
185.
> Around Elkart lake for 1 hr, H2O @210, oil at 200, was 190, 190 before we
were
> back to the pits.   tom S
>
> HPC has oil sheading coatings for crank, rods, block etc.. Tom S
>
> Bruce Plecan wrote:
>
> > Has anyone run any "independent" testing on these barrier coatings for
what
> > they actually have seen as an improvement pre+post coating?.
> >   Has any one run any endurance tests?.
> > Do I need mention that this might need a complete recal to get right.
> > Bruce
>
>
>