Problem with getting off idle with Stock Rover MEMS

[Rich M]

> -----Original Message-----
> From: owner-diy_efi at diy-efi.org [mailto:owner-diy_efi at diy-efi.org]On
> Behalf Of Ade + Lamb Chop
> Sent: 11 April 2000 18:37
> To: diy_efi at diy-efi.org; diy_efi at diy-efi.org
> Subject: RE: Problem with getting off idle with Stock Rover MEMS
>
>
> At 12:57 11/04/00 +0100, Rich M wrote:
> >Rover MPi MEMS certainly uses TPS (yes, it is a pot) to deliver accel.
> >enrichment, MAP is used for steady state running.
> >Does the engine behave the same if you disconnect the TPS?
>
> Havn't tried... Worried about causing damage... Sure I am OK to do this?

We have done this during testing, never caused us a problem, all should
return to normal (or at least how it is at the moment!) when you reconnect.
As always, no guarantee - it's your choice in the end to try or not.

> >Have you tried measuring the pot resistance with a multimeter?
>
> It is impossible to get to insitu!!

Ah... Mini... yeah, didn't stop too long to think about that! There's a lot
more room on a 214!

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org