crank position sensor

[Programmer]

3 wire sensors use slots--two wire sensors need a magnet.
Lyndon.
-----Original Message-----
From: brucep at ptd.net <brucep at ptd.net>
To: diy_efi at diy-efi.org <diy_efi at diy-efi.org>
Date: May 2, 2000 3:42 PM
Subject: crank position sensor


>I'm planning on using a GM crank position sensor (two wire variable
>reluctance style) to trigger a 4 pin GM module on a single cylinder engine.
>My question is do I use a metal pole peice with a slot cut in it or do I
>make a nylon collar with a peice of metal epoxied into it?
>
>The module has to "see" voltage so I would assume I would need the nylon
>with the metal in it, any ideas of size and width I'd need? I probably
>answered my own question but I'd like some input from the "EFI brain
>collective" Any help? TIA
>
>
>            There are those that have, and those that will . . .
>
>Homepage   http://www.geocities.com/brucepts
>
>
>
>---------------------------------------------------------------------------
-
>To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
>in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org