Idle air with threaded port?

[Rich M]

Excuse me if I've got the wrong end of the stick - is it the thread that's
important , or the fact that the valve is able to fit remotely/independently
of a specific flange fitting?
A lot of Bosch (Motronic) valves fit inline with hoses fixed by hoseclips,
5/8" - 3/4" or thereabouts I think.
Rich

> clayb wrote:
> >
> > Hi everyone,
> >
> > Is it possible to get an idle air motor with a threaded port (1/8"
> > national pipe thread, for example)? If memory serves correctly, the ford
> > and GM units want to bolt onto a specific flange. What about an adapter
> > to get from the IAC to threaded connect?
> >
> > Suggestions and part numbers welcome.
> >
> > - Clay

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org