Ignition Only

[rr]

Don't know much of anything about the engine. However, there are GM ecms
available that run a DIS that should work. All that is required to run ignition
only, is to turn off the error codes for the fueling. Then setup the SA tables as
you need them. A minimum of sensors are required: MAP, crank, coolant,
vss. I think the '730 has been used on 4-cyl DIS, but am not positive.

BobR.

Tom Parker wrote:

> matt <matthewgreen at powersoft-services.co.uk> wrote:
>
> >What options do I have on the DIY front for running
> >the ignition ? as my engine (Vauxhall 2.0 16v ECO TECH) has no
> >place for a distributor .
>
> >ECU's for ignition cost about 350 ukpounds.. are there any other
> >options for me ?
>
> Could you run the ignition from the original EFI computer and just not connect
> the injection system? Would the computer complain if there were no
> injectors connected? You might have to include the oxygen sensor. You would
> have to include the air sensors on the inlet mainfold. If it is MAF you might
> have some problems but if it is MAP I would expect it to work.
>
> --
> Tom Parker - parkert at ihug.co.nz
>            - http://www.geocities.com/MotorCity/Track/8381/
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org