Source for small throttle bodies Re: DIY_EFI Digest V5 #364

[Swayze]

I read the following in the digest and am interested in getting a look at
these,
does anybody have any particular MYET combo that these would definitely be
on?
Do you happen to know what the bore size was on them (48,52,56mm?).

> From: "Carter Shore" <clshore at yahoo.com>
> To: <diy_efi at diy-efi.org>
> Sent: Sunday, October 29, 2000 11:25 AM
> Subject: Re: Source for small throttle bodies
>
>
> > When I rebuilt the carb on my Dodge slant 6, I noticed
> > that the twin butterfly throttle body was a seperate
> > piece, a flat plate maybe 1/2" thick that bolted onto
> > the main carb body. It would be easy to adapt this
> > piece to just about anything.
> > I do not recall the carb manufacturer, but they built
> > millions of these things, so junkyards ought to be a
> > good source.
> >
> > Good luck,
> >
> > Carter Shore
> >
.................>
> The only factory two barrel carb that I know of installed on slant sixes
> was the Carter BBD.  This setup was called a "Super Six," and was only
> offered in the late 70's - at least in the States.  However, Carter BBD's
> turned up on a wide variety of Chrysler products from the 60's and 70's.
> I've got one installed onto my Dart, although I can't remember if it has
> the detatchable throttle plate you describe.
> Finally, a question on this list I can answer! :-)
>
> Matt Cramer

thanks

Mike
Swayze
mswayze at truswood.com
kswayze at bellsouth.net

.


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org