UEGO and alcohol

[Bruce Plecan]

Can I ask what your building?.
Have you tuned with alky before?.
Bruce
    Just wonder if the folks at Accel answering the phones are any better
then the Holley guys


> I'm looking to tune WOT w/nitrous and alcohol, so i need something much
> richer than stoich. My question is basically whether or not the sensor
will
> reflect the actual ratios of liquid fuel to air or not. Accel claims that
> you need "a true wideband sensor to tune alcohol because it's out of the
> range of the 5-wire sensors like SpeedPro uses"... this is more or less
what
> i was trying to verify. If the alcohol appeared as 6:1 (vs. 12:1 for gas)
> then this would make sense...
>
>
> > It's a matter of calibration, Jeff. The sensor/driver/meter will read
> > stoich wherever the alchohol mixture is stoich, and rich and lean to
> either
> > side of it. The only question is--what number will the meter give you
when
> > you are where???
> >
> > The actual VOLTAGE output from the sensor/driver will be the same at
> stoich
> > for alky as it would be for stoich for gasoline, etc.
> >
> >
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org