Australian NTK/NGK sensor purchase

[Peter Gargano]

M&W Ignitions use the NTK sensor in their (new) WB.

Phil Lamovie wrote:
> 
> Check with Motec they are using the same sensor for their new wideband

I understood that MoTec used the LSM11, but I guess I'll check
during business hours (I believe an LSM11 is Bosch # 0 258 104 002
(2.5 m leads), or 0 258 104 004 (0.65 m leads). Of course, equating
a Bosch part number with a "product name" is another problem too  8^(
case in point - the confusion with Bosch, Echlin, etc. rebadging the
DIY-WB NTK sensor (NGK is the NTK parent co.)
 
> display and are retailing them at about $240 or so per each.

For me, the total cost is the deciding factor - how much is that
for a MoTec - even if we're not quite comparing apples?

> The bulk order may cut some mustard with them.

Well, a $385 -> $310 price drop (all AU$'s folks) when I spoke
about getting 5 - 10, without any haggling, means there's some
fat in the margins some (most?) spare parts places work on. Note
that AU$310 is ~US$158 (@AU$0.51 to US$), so, the one-off The
Parts Bin price of US$117 is US$41 less than the local price, and
with a bit of freight thrown in on a bulk order, I figure that's
still AU$70 less than I get it here in Canberra.

Peter.
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org