AW: Bosch peak and hold injectors
Rausch, Bernd
br at rnt.de
Thu Dec 13 21:20:38 GMT 2001
Hi Jason,
have a look at Bosch 0 280 150 363 (replacement for older 0 280 150
351). They flow 655cc/min at 3bar. They are very low impedance (0.7 Ohm)
and require 6A/1.4A current.
Best regards,
Bernd
-----Ursprüngliche Nachricht-----
Von: Jason Haines [mailto:jhaines at lingenfelter.com]
Gesendet: Mittwoch, 12. Dezember 2001 14:11
An: DIY_EFI
Betreff: Bosch peak and hold injectors
Does anyone know of any part numbers for Bosch peak-and-hold injectors?
I am
looking for injectors in the 65 to 85 lb/hr range (at 43 to 58 psi fuel
pressure).
Thanks,
Jason
----- End of forwarded message from owner-diy_efi at diy-efi.org -----
------------------------------------------------------------------------
----
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
in the body of a message (not the subject) to
majordomo at lists.diy-efi.org
----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org
More information about the Diy_efi
mailing list