DIY flowbench?

[Barry Tisdale]

In answer to several responses -

The heads are 1996 Vortecs, they *do* have the proper dividers between the
adjacent cylinders that seal against the intake gasket.  These heads were
completely cleaned up (esp. combustion chamber) prior to install, no real
port work other than matching & polishing.  Didn't remove any major metal
other than the valve guide protrusion into the valve pocket - smoothed &
blended there.

The turbo is TE60 compressor on a TD06 center section, 14cm turbine
housing, exhaust sys is 3" straight back, no cat, hi flow muff.

New block going in has JE pistons, Eagle H beams, etc - the usual goodies.

Per Lew P, the SyTy manifold was stopped short of full development due to
$$ constraints, the engineers knew @ the time there was a defect - the
prototype is what they went with.

Just wanted to know if there's any improvement on a DIY basis so's to
equalize the flow amongst the cylinders better.

Barry
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org