DIY flowbench?

[ECMnut at aol.com]

>  Per Lew P, the SyTy manifold was stopped short of full development due to
>  $$ constraints, the engineers knew @ the time there was a defect - the
>  prototype is what they went with.

Wow, those ba$tards.. 
 I wonder if the problem was related to the recessed port divider.
I didn't make a career out of it, but I did a plug read and they
looked the same after a hi-boost thunder-run with the ports sealed to
the intake manifold..
Hmmm.. you could always run a a little bigger injector on #1.
What was Lew's fix for the situation?

>  Just wanted to know if there's any improvement on a DIY basis so's to
>  equalize the flow amongst the cylinders better.
  
Mike V
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org