DIY flowbench?

[Bruce]

From: <ECMnut at aol.com>
Subject: Re: DIY flowbench?
> >  Per Lew P, the SyTy manifold was stopped short of full development due
to
> >  $$ constraints, the engineers knew @ the time there was a defect - the
> >  prototype is what they went with.
> Wow, those ba$tards..
>  I wonder if the problem was related to the recessed port divider.
> I didn't make a career out of it, but I did a plug read and they
> looked the same after a hi-boost thunder-run with the ports sealed to
> the intake manifold..
> Hmmm.. you could always run a a little bigger injector on #1.
> What was Lew's fix for the situation?
> >  Just wanted to know if there's any improvement on a DIY basis so's to
> >  equalize the flow amongst the cylinders better.

Larger Plenum  <g>
Bruce

> Mike V


----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org