Bosch O2 / Sensor ,any good ?

[Dr Flowgood]

thank you for  the reply

DJ

rr wrote:

> Should work just fine for that. The wiring might be as follows:
>
>     White wires: +12v & ground for heater.
>
>     Black: signal out
>     Gray: signal ground (may also be attached to shell)
>
> BobR.
>
> Dr Flowgood wrote:
>
> > I picked up a couple Bosch 02 sensors at a swap yesterday. Can I use this with a good
> > volt meter for a relative rich/lean indicator ?  I just want to experiment with them on
> > my old Camaro. (carb) My question is, are these any good and what should they cost ?
> > its a 4 wire unit.
> >
> > It says this on it:   Bosch 08429A0           982
> >                            0258 005 791/792   12v
> >                            Ford F8TF-9G444-CA OD29
> >
> > Thanks a bunch   ( be easy on me  :')
> >

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org