Damping oscillating boost gauge needle???

[Larry Heath]

Put a small diameter orifice ( could be made out of just about anything)
inline with the gauge this should dampen the oscillations.

Later Larry

----- Original Message -----
From: "Chris Wilson" <chris at formula3.freeserve.co.uk>
To: <diy_efi at diy-efi.org>
Sent: Tuesday, May 08, 2001 5:52 PM
Subject: Damping oscillating boost gauge needle???


>
> I use a make of boost gauge that works fine in 90% of installations but
> occasionally the needle will sense intake pulses and go haywire,
> oscillating about and buzzing. Any ideas for a cheap and simple in hose
> damper to put between manifold and gauge? Thanks.
>
> --
> Best regards,
>            Chris Wilson
mailto:chris at formula3.freeserve.co.uk
>                                      http://www.formula3.freeserve.co.uk
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org