Modifying/fabricating manifold for injectors?

[Kris Weldy]

Look on a volvo 244 turbo or a volvo 242 turbo-from 1980 to 1986 i
guess,they have cis injectors with the mounting bracket to mount on to
anything-just machine the whole and  drill a hole for the mounting screw-tap
it and you should be set-hope that helps-been doing volvo performance for
quite a while-can give tips on tweaking the k jet fuel distributor as
well.Your freind,
Kris Weldy
Arlington Texas
Jap spec Supra
Mini hennessey Viper(dodge avenger * bling * bling).
Volvo 760ti-now sold-very modified with haltech and other goodies..
www.badbricks.com

----- Original Message -----
From: "Dave Williams" <dave.williams at chaos.lrk.ar.us>
To: <diy_efi at diy-efi.org>
Sent: Sunday, September 23, 2001 3:24 PM
Subject: Modifying/fabricating manifold for injectors?


>
> -> Does anyone have suggestions for mounting  mechanical (K-jectronic)
> -> injectors in an existing manifold? Or even a fabricated manifold?
>
>  I used pieces of 3/4" aluminum round bar with holes drilled through.
> I don't remember the size, probably close to 3/8".  I was going to use
> O-rings to seal the nozzles, but figured some RTV sealer would probably
> work better.
>
>  I never got any farther than that.
>
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>

----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org