[Diy_efi] [Diy_efi]: prop sensing

[bill.shurvinton at nokia.com]

Dunno. This friend is Mr strain measurement so should be able to get =
whatever I want/need on that front cheap (note these are 2 different =
things :-)).

definately need to add to the pile of things to do before I get old.

Bill

-----Original Message-----
From: ext Greg Hermann [mailto:bearbvd at mindspring.com]

And what might be wrong with just using load cell motor mounts, properly
calibrated?? Possibly even mount "pads" containng hydraulic fluid =
together
with a diff pressure sensor for output instead of strain gauges??

With a VSS and various ways of sensing engine speed, you already have =
info
on what gear it's in.

Could lock up the tranny and use a (big) torque wrench on the front =
pulley
or prop shaft output to calibrate things.

Greg

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi