[Diy_efi] Re: Bruce -- Question on your *volt blaster*

[ROBO5.8]

Hi Bruce,

Can you tell us what you are using for a volt blaster?  Do you use a single
*volt blaster* for the ignition, injectors and fuel pump or separate
blasters.

Thanks Robo

----- Original Message -----
From: "Bruce" <nacelp at bright.net>
To: <Diy_efi at diy-efi.org>
Sent: Friday, April 26, 1996 9:54 PM
Subject: Re: [Diy_efi] Effect of detonation on measured mixture?


>
> I guess I might mention that I also run a *volt blaster* so that over 50%
> TPS my charging voltage jumps to 14.9.
> Figuring there is a several thousand fold multiplication for the ignition
> system, and that the injectors, and fuel pump also like the jump in
voltage,
> it's just a little insurance.
> Bruce
>
>
> ----- Original Message -----
> From: "Stephen Andersen" <SAndersen at advan-tek.com>
> Subject: RE: [Diy_efi] Effect of detonation on measured mixture?
> > I guess it is actually Coil Near Plug for Bruce's example.  My
> > car has Coil on Plug, and I know that on forced induction applications
> > spark becomes a problem above about 16 psi or so.  I would be interested
> > in discussing what the options are for spark at high boost to "boost"
> > the ignition setup.
> > Steve
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi