[Diy_efi] oopic2 based controller

[bill.shurvinton at nokia.com]

I was thinking more on the lines of

batch or sequential
Injector resolution required
Spark resolution required
fuel/Spark map size (8by8, 16by16 etc)
Dizzy, DIS or COP
MAF, SD, alpha-n
NA or turbo
Nos/Water
etc.

Without a spec you are flapping around a bit.=20

Traction control is a LOT more difficult. Perceived wisdom is that you =
should have a 32-bit device for this. But I haven't found a DIY-er who =
has made this work yet. Anyone?

-----Original Message-----
From: ext Bino Lardo [mailto:binolardo at hotmail.com]
Sent: 18 August 2002 18:42
To: diy_efi at diy-efi.org
Subject: Re: [Diy_efi] oopic2 based controller


I would like to be able to programe it whit my laptop connected to it =
via=20
the printer port.for the dev environement I have no preference the =
because I=20
will have to learn it anyway, so something easy to learn would be good. =
I=20
would like a board alredy assemble like a prototype one. as for what I =
want=20
to do, I would like to do the same thing as a efi332 but if I could ad=20
traction control and anti lag device it would be a plus. also something=20
really cheap. Tell me if you have other question. thanks


From: "William Shurvinton" <shurvinton at orange.net>
>Reply-To: diy_efi at diy-efi.org
>To: <diy_efi at diy-efi.org>
>Subject: Re: [Diy_efi] oopic2 based controller
>Date: Sat, 17 Aug 2002 22:07:21 +0100
>
>Can't answer that question without knowing what you want to be able to =
do.
>If you have a spec in terms of resolution and features and preferred =
dev
>environment then that will often point to a solution easily.
>
>Bill

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi