[Diy_efi] low-impedance injectors w/saturated driver

[bill.shurvinton at nokia.com]

Short answer is you can't. The saturated driver is designed for 1A per =
injector. P&H, even with resisitor will draw about 4A when peaking. =
Converting between the 2 is a few transistors.

Bill

-----Original Message-----
From: ext Scott F. Williams [mailto:sfwilliams at comcast.net]
Sent: 19 August 2002 19:26
To: diy_efi at diy-efi.org
Subject: [Diy_efi] low-impedance injectors w/saturated driver


Here's a super-basic question for y'all. To use low-impedance fuel =
injectors
with a saturated driver... all one must do is splice a resistor (with =
proper
resistane value) into the injector wires, correct? Or, is there anything
else involved?

Thanks,
--
Scott F. Williams
NJ Scirocco nut
'99 Subaru Impreza 2.5 RS
Mazda 323 GTX turbo "assaulted" vehicle
Golf GTI 16v "rollycar"
ClubVAC: "Roads found. Drivers wanted."



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi