Knock detector circuit

[Ken Richardson]

Where is the ESC module located?? In the distributor, under the dash, or
inside the ECM?

Thanks
Ken R.


----- Original Message -----
From: "steve ravet" <sravet at arm.com>
To: <diy_efi at diy-efi.org>
Sent: Thursday, January 10, 2002 3:07 PM
Subject: Re: Knock detector circuit


> Have you considered an ESC module from a C3 generation ECM?  Takes a
> knock sensor as an input, sends a knock/no knock signal to the ECM.
> Lots of info on them in the archives, but no schematics so may not learn
> much from it.
>
> --steve
>
> A70Duster at aol.com wrote:
> >
> > Does anybody have a schematic for making a knock detector circuit.  I'm
>
> --
> Steve Ravet
> steve.ravet at arm.com
> ARM,Inc.
> www.arm.com
>
> ----- End of forwarded message from owner-diy_efi at diy-efi.org -----
> --------------------------------------------------------------------------
--
> To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the
quotes)
> in the body of a message (not the subject) to majordomo at lists.diy-efi.org
>
>

----- End of forwarded message from owner-diy_efi at diy-efi.org -----
----------------------------------------------------------------------------
To unsubscribe from diy_efi, send "unsubscribe diy_efi" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org