[Diy_efi] DIY-WB wiring

[rr]

These colors are correct. (except the calibration resistor
which has no sensor wires). For reference the schematic and
the checkout guide also list the wire colors.

BobR.

renaud wrote:
> 
> Hello,
> 
> I would just need confirmation about the color wires on the NTK sensor
> before plugging it on my PCB.
> -Heater +: Orange
> - '"   "    neg.: Yellow
> -CalR: Green and Blue, no polarity.
> -Ip: White
> -Vs: Red
> -Vs/Lp ground: Black
> Is that right?
> 
> Thanx again.
> Renaud.
>

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi