[Diy_efi] DIY-WB wiring

[Steve Wong]

That should be right.  See a wiring diagram here:
http://www.techedge.com.au/vehicle/wbo2/wiring.htm

Steve Wong

----- Original Message ----- 
From: "renaud" <leguillr at COURRIER.UMontreal.CA>
To: <diy_efi at diy-efi.org>
Sent: Tuesday, June 25, 2002 5:23 AM
Subject: [Diy_efi] DIY-WB wiring


> Hello,
> 
> I would just need confirmation about the color wires on the NTK sensor 
> before plugging it on my PCB.
> -Heater +: Orange
> - '"   "    neg.: Yellow
> -CalR: Green and Blue, no polarity.
> -Ip: White
> -Vs: Red
> -Vs/Lp ground: Black
> Is that right?
> 
> Thanx again.
> Renaud.
> 
> 
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi