Fw: [Diy_efi] compression ratio

[elcamino73]

----- Original Message -----
From: "elcamino73" <elcamino73 at mindspring.com>
To: <Diy_efi at diy-efi.org>
Sent: Monday, May 06, 2002 9:43 PM
Subject: Re: [Diy_efi] compression ratio


> Just a quick comment. There was an article in one of the magazines quite a
> > while ago that talked about a Hi rpm Ford racer that periodically
removed
> > the heads and shaved the pistons with a disk sander to compensate for
> > rod/piston stretch. Seems that too much squish is as bad as too little
(or
> > is that too little/too much???) You could turn those 9.5s into 9.0s...
> > Just a cheap $.02... TomS
> >
> I've already spoke to JE pistons about machining the slugs. They suggested
> that I don't. These are very specialized blower d dish with 3.75 stroke
and
> 6 inch rods. The frikin wrist pins are up to the bottom of the 2nd ring
> land.
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi