Fw: [Diy_efi] compression ratio

[elcamino73]

So do you have any onions of how much to use in my particular case?



----- Original Message -----
From: "Greg Hermann" <bearbvd at mindspring.com>
To: <Diy_efi at diy-efi.org>
Sent: Tuesday, May 07, 2002 9:00 PM
Subject: Re: Fw: [Diy_efi] compression ratio


> At 12:53 AM 5/8/02, Axel Rietschin wrote:
> >From: "Greg Hermann" <bearbvd at mindspring.com>
> >> >> > BTW... ive heard that the maximum water that can be injected
before
> >> >> > water-lockup can occour is 50% of fuel.
> >> >>
> >> Apparently you have a good source for urban legends---
> >
> >Water-lockup is indeed probably a little further away ;-) but 50% of fuel
> >mass was indeed experimented by someone (Harry Ricardo? - I don't have a
> >quote handy so please don't ask) and is most probably the most water you
> >ever want to inject.
> >
> >This may be helpful:
> >
> >http://retro.co.za/efi/DIY_EFI/2000/efi5-039.txt
> >
> >
> >--Axel
>
> 70% of fuel mass flow is a bit closer to the theoretical maximum (optimum)
> H2O flow rate which is beneficial--as supported both by thermodynamic
> calculations (the maximum increases somewhat as compression ratio
> increases). and by Sir Harry's work.
>
> Sir Harry went quite a bit FURTHER than the optimum, proving also that
> water flow above the optimum simply results in reduced power and
> efficiency, not in engine damage!
>
> Greg
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi