[Diy_efi] Base Fuel Calculations for turbo

[md4etal]

go get the book Turbochargers by Hugh MacGinness published by HP books.  It
will go a long way to helping you.

Mike Dekutoski
----- Original Message -----
From: "Gregory Croft" <gcroft at wideopenwest.com>
To: <diy_efi at diy-efi.org>
Sent: Sunday, January 05, 2003 11:01 PM
Subject: Re: [Diy_efi] Base Fuel Calculations..


> Yeah, I have a Turbo System.
>
> What VE calc would I use then?
> Stock injectors for this engine are 19lbs. :)
>
> Are there any calcs for air temp compensation?
>
> Greg
>
> ----- Original Message -----
> From: <Tlsalt at aol.com>
> To: <diy_efi at diy-efi.org>
> Sent: Sunday, January 05, 2003 9:04 AM
> Subject: Re: [Diy_efi] Base Fuel Calculations..
>
>
> > Gregory Croft wrote,
> >
> > Thanks for the formula. :)
> >
> > For my 122 C.I. Engine, with 55lbs injectors..
> > I got a whopping 3.6ms pulse width. heh..
> >
> > Very interesting..
> >
> > Hello Greg,
> >
> > That sounds about right.  Four 55 lb injectors should be good for over
> > 350hp......are you talking about a turbo ?  In that case, your VE will
be
> > much higher than 80%. A N/A 122 cu engine would use injectors half that
> size.
> >
> > Paul
> >
> > _______________________________________________
> > Diy_efi mailing list
> > Diy_efi at diy-efi.org
> > http://www.diy-efi.org/mailman/listinfo/diy_efi
> >
>
>
>
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi
>


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi