[Diy_efi] Pre-TB water/alky nozzle orientation

[arnie]

My personal preference are the quality TG series small capacity 'full
cone' spray nozzle assy. from Spraying Systems Co., an agricultural supply
mfr. in the US.  The complete brass assy. ( cap, body, check valve, and
strainer ) is available in flows from .042 to 3.6 gpm with operating
pressures from 20 to 150 psi. ( B section - Pg. 58/60 )
http://www.spray.com/    First became aquainted from a chap in Oz, whose
site is no longer available.

GAS

----- Original Message -----
From: "Mike" <erazmus at iinet.net.au>
To: "List for general do-it-yourself EFI talk" <diy_efi at diy-efi.org>
Sent: Saturday, January 11, 2003 12:01 AM
Subject: Re: [Diy_efi] Pre-TB water/alky nozzle orientation


> I could do with a couple or maybe 4 in Perth, Western Australia
> does anyone want to participate in getting a few over to save
> on freight - Bernd  ?
>
> rgds
>
> mike
>
> At 07:58 PM 1/10/03 -0500, you wrote:
> >I like them a lot - I think they mist very well.  - for water these
> >mini misting nozzles work great.  They can be found at
> >http://www.mcmaster.com - search for nozzle and then click on
> >'Adjustable Spray Angle High-Pressure Nozzle'.  Part numbers
> >of 3178K61 through 3178K77 for the full cone type and they
> >come in flow ratings of 1 to 15GPH at 100psi.
> >
> >
> >Kinda late to the thread, but I recently took some video footage
> >of my DIY water injection system spraying inside the throttle body.
> >I'm using mcmaster car mini misting nozzles, and they spray
> >perpendicular to the air flow.  This setup seems to be working well
> >for me, but I'm wondering if there are suggestions?
> >Thanks!
> >http://cybrina.mine.nu/Description.htm
> >http://cybrina.mine.nu
> >
> >joeo



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi