[Diy_efi] Toyota 1MZ-FE coils ... again

[k1drbar]

... I'm not used to dealing with the Toyota parts folks, but in general it seems to me that since
there are reasons it might be necessary to repair or remanufacture a wiring harness the connector
parts should be available from the parts department.  If you don't have luck at one dealer try
another.  Check online resources.  I'm most familiar with VWAG products, and they show the
connectors in the "repair parts" section of the fiche.  It may be difficult, there aren't usually a
lot of pictures there ... perhaps if you can get a part number from someone who has a car that uses
the coil ...

Steve Buchholz
San Jose, CA (USA)

----- Original Message -----

As it turns out I think that is the exact same coil on my Tundra.  I'd bet
there are a lot of newer Toyotas (all of them?) that have this style coil.
Have you tried a junk yard?

-Andrew

On Friday 06 June 2003 02:50, Gerard wrote:
> I have some better images up at the following URLs:
>
>   http://www.2226.co.za/images/lexcoilplug-002.jpg
>   http://www.2226.co.za/images/lexcoilplug-003.jpg
>



_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi