[Diy_efi] Re: Electronic expertise requested

[Jeffrey Engel]

How much more would it cost to install two whole
units?  Several of the sensors wouldn't take kindly to
being hooked to 2 units.

Jeff Engel
--- Carter Shore <clshore at yahoo.com> wrote:
> Dan,
> A KISS solution is a 4PDT toggle switch for the
> wires
> to the injectors. Obviously, use a MIL SPEC or
> aircraft rated unit.
> What about ignition? Are you using the EDIS? It has
> the capability to run independently without an EEC,
> but depends on the crank sensor, so there's another
> SPOF, unless you fit a second sensor (180 degrees
> from
> the primary) and EDIS.
> Some of the inputs may be OK to wire to both EEC's,
> but the temp sensors depend on a pullup that's
> inside,
> so you'll have to account for that. Either another
> switch, or externalize to a single pullup resistor.
> 
> Carter Shore
> 
> 
> 
> __________________________________
> Do you Yahoo!?
> SBC Yahoo! DSL - Now only $29.95 per month!
> http://sbc.yahoo.com
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://www.diy-efi.org/mailman/listinfo/diy_efi


__________________________________
Do you Yahoo!?
SBC Yahoo! DSL - Now only $29.95 per month!
http://sbc.yahoo.com

_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://www.diy-efi.org/mailman/listinfo/diy_efi