[Diy_efi] HiWay Mode Question

Jim Powell jpowell
Thu Apr 14 12:48:23 UTC 2005


Guys what can I do about this email.. I am over whelmed with email, and
there is no way that I can answer let alone read all these many emails.. How
do I get off the list..? Thanks...

-----Original Message-----
From: diy_efi-bounces at diy-efi.org [mailto:diy_efi-bounces at diy-efi.org] On
Behalf Of David Dowell
Sent: Monday, April 11, 2005 6:23 PM
To: diy_efi at diy-efi.org
Subject: [Diy_efi] HiWay Mode Question

I've installed a 747 on an older RV.  With gas prices being what they are,
I'm looking for max mpg.  Therefore, I've implemented the Hiway Mode Patch
(Hiway747.zip) that I found on the diy-efi uploads.  I've also modified my
ALDL stream so I can monitor the Hiway timer (at L0078) and the commanded
AFR (at L00A5) so I can see what is happening.

When I drive the vehicle, and all the qualifications are met (temp above set
value, mph above a threshold for more that the set time and MAP below a
threshold) it refuses to set the Hiway mode timer and go into Hiway mode
UNTIL I stick my foot in it and push the MAP above the upper limit
threshold.  It then immediately sets the Hiway timer and drops into Hiway
mode when the timer hits the threshold.  It then seems to behave normally
and drops out of Hiway mode (zero's the timer) when the speed drops below
the threshold.  BUT, it also holds hiway mode no matter what the MAP reading
when the speed is above the threshold.

Has anyone else seen this?  I've looked at the assembler code and the
comparisons seem to be correct.
Does anyone have any idea as to why this is happening?

Thanks,


_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi






More information about the Diy_efi mailing list