[Diy_efi] Strain gauge on engine mounts

[Bobby Yates Emory]

Frederic,

Mat be a problem with point of reference - driveshaft = more speed, less 
torque - rear axle = less speed, more torque

Bobby

On 4/20/05, frederic <frederic at midimonkey.com> wrote:
> 
> > typical rear axle the axle shafts are just about 1" diameter and they 
> handle
> > 3 times the torque of the drive shaft. This should give you a degree or
> > two of twist to work with.
> 
> Wouldn't it be less torque, since the diff gears it down?
> 
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
> 



-- 
Toward freedom,

Bobby Yates Emory
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/diy_efi/attachments/20050420/697ed390/attachment.html