[Diy_efi] Strain gauge on engine mounts

[Rod Hiorns]

I should post a revision here ... G (steel) is more like 77GPa
so the twist is more like the 0.1 degrees (for a 0.1" wall) as
Milosz Kardasinski already posted. Sorry for any confusion.

I still think strain gauges on the shaft is the way to go.

HTH,
Rod

-----Previous Message-----
From: diy_efi-bounces at diy-efi.org
Sent: Wednesday, April 20, 2005 11:44 AM
Subject: RE: [Diy_efi] Strain gauge on engine mounts

OK, I'll guess a few values ...
[SNIP]