[Diy_efi] swap part questions

[Mike V]

At 09:53 PM 5/18/2005 -0500, you wrote:

>ftp://diy-efi.org/uploads/sgr/transmount.jpg
>
>This is the stock '98 4L60E mount.  My tunnel doesn't have quite as much
>room as the pickup did, I'd like to find a mount that's about an inch
>shorter.  I thought a Camaro might have something shorter but it's
>completely different, at least in '98.  Any suggestions for a different
>year or model that might put the trans closer to the cross member?

Have you already made full use of the trusty sledge-O-matic on the trans 
tunnel?



>ftp://diy-efi.org/uploads/sgr/airbox.jpg
>
>The stock air inlet has some kind of box attached, about 6"x6"x6", for
>noise reduction?  Doesn't fit under the hood, so had to go.  Any clever
>ideas for filling the hole where it connects?  A 2" PVC cap almost fits
>but is just too small.

I'm not getting the big picture on the airbox setup.
If you can send me some more pics or diagrams, i might have
some tubing parts I can send you.
Most of my spares are 3 inch I think.
MIke V