[Diy_efi] My Tach is crazy, Ignition problem.

[Facundo Lozano Ureta]

Only the TBI, and GM HEI Distributor, but my engine is Still being a Toyota 
2F inline 6 Cilynder.


----- Original Message ----- 
From: "Dustin Lof" <bubblesjrtwo at yahoo.com>
To: <diy_efi at diy-efi.org>
Sent: Tuesday, November 08, 2005 12:13 AM
Subject: Re: [Diy_efi] My Tach is crazy, Ignition problem.


>
> Are you installing a 4.3 or just the tbi?
> is it a GM module and coil or is it MSD?  Dustin Lof
> --- Facundo Lozano Ureta <flozano at twistedandes.com>
> wrote:
>
>> Hello
>>
>> I have a toyota Land Cruiser with 2F engine (I6) and
>> I'm installing a 4.3
>> Chevy TBI.
>> My engine run, but my tach is crazy on high RPM
>> (2500 RPM) and some times at
>> IDLE, and at the same time my ignition don't fire
>> when the tach is crazy.
>> My ignition module is new, I use an 1227747 ECM, and
>> a custom chip.  I have
>> a GM HEI Dist, and the ignition module is installed
>> outside of the
>> distributor.
>> When I disconect the timing connector, My tach work
>> grat and my ignition
>> work witout fails.
>> any idea?
>> may be I have problems with my custon chip or my
>> coil?
>>
>>
>>
>> _______________________________________________
>> Diy_efi mailing list
>> Diy_efi at diy-efi.org
>> http://lists.diy-efi.org/mailman/listinfo/diy_efi
>>
>
>
>
>
> __________________________________
> Yahoo! FareChase: Search multiple travel sites in one click.
> http://farechase.yahoo.com
> _______________________________________________
> Diy_efi mailing list
> Diy_efi at diy-efi.org
> http://lists.diy-efi.org/mailman/listinfo/diy_efi
>
>
>