[Diy_efi] Question about TBI fuel pressure

[Bret Levandowski]

I don't. It's a universal, frame mounted pump that comes with the plug, fittings and mounting hardware. NAPA really only carries 3 different pressures in uni pumps. One around 7 for carbs, one around 32 (TBI) and one at 80 (TPI).If you have probs locating the correct one, let me know and I'll have the number dug up.  Ski

"Tomlinson, Brandon B" <Brandon_Tomlinson at baylor.edu> wrote:Do you have a part number? Or an model application? Thanks, BranZ 
--------------------------
Brandon Tomlinson
Communication Tech II
254.710.4383


-----Original Message-----
From: diy_efi-bounces at diy-efi.org 
To: jimkyser at ieee.org ; diy_efi at diy-efi.org 
Sent: Thu Sep 22 18:19:06 2005
Subject: Re: [Diy_efi] Question about TBI fuel pressure

In tank is good for protection, not so good for replacement. NAPA carries an inline pump for about $75 that puts out 32PSI. The TBI unit will regulate it down to 12 providing your return line is a minimum 5/16". Smaller than that and it will back up to around 20. I personally run 18PSI on my TBI and it seems to be fine (for my app). If you are concerned about damaging it on the trail, get a piece of 'C' channel the same size as your frame and 1/8" - 3/16" thick. Cut it 4" longer that the pump and mount it to the frame to create a box. If it's slightly smaller than your frame, it's a little easier. You can just drill two holes in the frame and two in the channel and tap the cannel for quick bolt on. Otherwise you need to fab brackets. Ski

Jim Kyser wrote: 

I am adapting a TBI system to my 1946 Willys Jeep with a Buick V6. 
(yeah, I know I could adapt a Buick TPI setup but the parts are much 
more expensive)

My question regards fuel pressure. I would ideally like to run an intank 
pump and am looking at the pump from a Pontiac Aztek. Basically, the 
pump and fuel level sensor are all mounted together in an assembly that 
bolts in from the top of the tank though the typical large opening. The 
problem is that the Aztek pump is for a TPI setup and puts out upwards 
of 40 PSI. I know that the TBI systems need more like 5 PSI. Could I 
just put a regulator inline to drop the pressure down?
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi


________________________________

Yahoo! for Good
Click here to donate to the Hurricane Katrina relief effort. 
_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi


		
---------------------------------
Yahoo! for Good
 Click here to donate to the Hurricane Katrina relief effort. 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/diy_efi/attachments/20050922/314208c3/attachment.html