[Diy_efi] [slightly ot] Differential Pressure Measurement gauge, alternatives ?

[Gregg Eshelman]

--- ian <spyro at f2s.com> wrote:
<clip>
> optional:
> 
> 10) peltier cooler to chill water entering the rail
> (remember, it
> recirculates so the water in the reservoir will
> chill more and more over
> time)

You'll definately want an airflow source for the hot
side of the peltier that comes from outside the engine
compartment and exhausts to outside it too.

You'll also want a LARGE cooler block with a very long
or otherwise high area path for the water to flow
through so it can shed as much heat as possible.

They're not terribly efficient and a lot of the input
energy goes to waste as heat out the hot side. They're
much better heaters than they are coolers.

-- 
www.fandemonium.org
August (Fri) 1st, (Sat) 2nd & (Sun) 3rd, 2008


       
____________________________________________________________________________________
Boardwalk for $500? In 2007? Ha! Play Monopoly Here and Now (it's updated for today's economy) at Yahoo! Games.
http://get.games.yahoo.com/proddesc?gamekey=monopolyherenow