[Diy_efi] TPI Question

[Bill Hamilton]

What do you consider the latest MAF code.If not a code for the 7165 then it can't be used in the 7165 AFAIK.There are a few ECM/PCM that share hardware like the 7727/7730/7749 or 7060/7427/6395 that can share bin codes but I do not know of any that share with the 7165 that would actually gain you anything.The gears are compensated for in the DRAC/VSSB and there are programming options for manual and autos since GM used both.Unless someone wants to retype it all, I would recommend heading over to www.thirdgen.org and read up on their programming FAQs.Most I see that used to run the 7165 end up swapping it out for something newer.
 Date: Tue, 30 Oct 2012 08:18:03 -0500
From: mfisher at ckt.net
To: diy_efi at diy-efi.org
Subject: Re: [Diy_efi] TPI Question

Nobody has any thoughts?
On Oct 22, 2012 10:33 PM, "Mike Fisher" <mfisher at ckt.net> wrote:

Alright guys, to add to this conversation....  I found my old 1227165 ECM and ABWT MAF memcal.  Here is my next question on this one.  Can these be reprogrammed to the latest MAF code?  And can it be programmed for gears, manual shift, etc?  I am just not sure what my options are.  Since I am not sure what mods have been done with this engine I am using, it may just be better to use a MAF setup since it will adjust better without having to be fine tuned as much.



On Wed, Oct 17, 2012 at 10:49 PM, Brian Koontz <brian at pongonova.net> wrote:


On Wed, Oct 17, 2012 at 08:37:18PM -0700, Bill Hamilton wrote:

>

> ATSN shows as 1990 3.1 auto16197128 ecmI have an excell spread sheet

> on binderplanet. I think it was originally on Moates before his

> crash.



It's probably the same one.  I should work on getting all that data

online in a format that's updatable, because my copy has all sorts of

little notations and whatnot.



  --Brian

_______________________________________________

Diy_efi mailing list

Diy_efi at diy-efi.org

http://lists.diy-efi.org/mailman/listinfo/diy_efi





-- 
Mike Fisher
Network Administrator
Southeast Kansas Education Service Center
http://helpdesk.greenbush.org


(620) 724-6281

This message is from the Southeast Kansas Education Service Center. This message and any attachments may contain information that is confidential and/or legally privileged. It is intended only for the use of the individual(s) and entity named above as the recipient of the message. If you are not the intended recipient of this message, or if this message has been addressed to you in error, please notify the sender immediately. We ask that you please delete this message, and do not deliver, distribute or copy the message or any attachments. Thank you. 





_______________________________________________
Diy_efi mailing list
Diy_efi at diy-efi.org
http://lists.diy-efi.org/mailman/listinfo/diy_efi 		 	   		  
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://lists.diy-efi.org/pipermail/diy_efi/attachments/20121030/d5d17ff0/attachment.html