Dwell Control

[Ward]

Thats what I guessed, How are yuou generating the Engine signal.

Also you may wish to consider simulating the normal signal to the DIS module
etc. This will help ypu understand to process. 

The DIS mudule should run ok on its own, with little or no advance if it has
the proper input signal, else I think the default is waht you are seeing. 

Ward 



On Sun, 11 Apr 1999 23:47:26 EDT, Tedscj at aol.com wrote:

> In a message dated 4/11/99 11:26:22 PM Eastern Daylight Time, 
> wspoonemore at excite.com writes:
> 
> > Most DIS systems have two inputs, generaly  Cam and Crank, You haven
cited
> >  which DIS system you are using and how you are trying to use it.
> >> It sounds
> >  like you are trying to replace a dist sys ?
> 
> YES
>   
> >  Remenber the DIS module uses both sig's to sort all of this out, also
the
> >  ECM gets both signal from the engine, Cam and Crank. 
> >  
> >  I have done this on LT1's used a crank triger from a Cad.
> >  
> >  Ward
> 
> I am using the DIS from a 2.8 - 3.1, '87 -'92 V6 (GM).  It is a batch fire

> system.  There is one magnetic pickup that sends a synched signal (6+1) to

> the DIS.  The DIS sends an un-synched signal to the ECM (similar to an HEI

> system).
> I am trying to get a .bin from an HEI based car (SyTy .bin) working with
my 
> DIS module.  So far, no luck.
> 
> Ted





_______________________________________________________
Get your free, private email at http://mail.excite.com/