Halp ANHT cal

[EFISYSTEMS at aol.com]

Hi Peter,
      You've probably already done this but did you convert the "limp chips" 
to a 6 cyl??? From what I understand these are looked at during initial 
crank.....hth's
-Carl Summers

In a message dated 7/10/99 1:02:10 PM Pacific Daylight Time, 
pfenske at bcit.bc.ca writes:

<< Subj:	 Halp ANHT cal
 Date:	7/10/99 1:02:10 PM Pacific Daylight Time
 From:	pfenske at bcit.bc.ca (Peter Fenske)
 Sender:	owner-gmecm at esl.eng.ohio-state.edu
 Reply-to:	gmecm at efi332.eng.ohio-state.edu
 To:	gmecm at efi332.eng.ohio-state.edu
 
 
 
 Hi Folks
 
 For lack of anything to do I have been trying to adapt
 the ANHT corvette cal( AUJP similiar) to run my 97 V6 vortech..
 
 All done but having problems with startup.. Once running it
 runs good.
 
 I have altered the startup pw vs temp to no avail. I did reset the
 tps vs startup pw table since the mult is set to 1 stock.
 I also altered the inject vs rev count table to no avail.
 
 The only thing is IAC opening counts might be too big for V6?
 Is 160 counts for V8
 
 any ideas would be appreciated.
 
 TIA;peter
  >>