3800 series II swap in Lesabre T-type

[TK]

Fiero people have done this. Check out their sites.

Terry
----- Original Message -----
From: Bartz, Jamison <Jamison.Bartz at COMPAQ.com>
To: <gmecm at efi332.eng.ohio-state.edu>
Sent: Monday, July 26, 1999 8:45 AM
Subject: RE: 3800 series II swap in Lesabre T-type


> I also am looking into swapping a 5spd for the T4-440 in my Cutlass
Supreme.
> Could you please copy me in any response also.
>
> Thanks,
>
> Jamie
>
> Jamison Bartz
> BIOS Development Engineer
> Compaq Computer Corporation
> Phone: 281-518-3372
> Pager: 281-722-5370
> E-Mail: jamison.bartz at compaq.com
>
> -----Original Message-----
> From: Kevin [mailto:speakerconnection at home.com]
> Sent: Monday, July 26, 1999 10:25 AM
> To: gmecm at efi332.eng.ohio-state.edu
> Subject: 3800 series II swap in Lesabre T-type
>
>
>
> Hey all, hope everyone is well..
>
> The reason I am now writing is to thank everyone for the advice on the
> injector cleaning. After getting them to stop leak.. the idle has really
> improoved a lot. They were pretty off balance.
>
> A day after getting it all right.... I blew my tranny... 2nd and 3rd slip
> pretty bad on my T4-440.  I am looking at putting in a 4T-60E and have
seen
> that these trannies are still used today in the monte carlo and lumina's..
> does anyone know which one would have a 3.06 final drive ratio?
>
> My other option I have been very slightly thinking about, is using a 5spd
> from a 94 Z-24... are there any thoughts on this..?? would there be
problems
> with code in the eprom? am I making too much of a headache in work ? I
know
> I need a clutch.... pedal, master cylinder... has this ever been done
> before?   Any response is greatly appreciated.. hope to hear from you all
> soon.
>
> Yours Truly,
>
> Kevin
>