3800 series II swap in Lesabre T-type

[Bartz, Jamison]

I also am looking into swapping a 5spd for the T4-440 in my Cutlass Supreme.
Could you please copy me in any response also.

Thanks,

Jamie

Jamison Bartz
BIOS Development Engineer
Compaq Computer Corporation
Phone: 281-518-3372
Pager: 281-722-5370
E-Mail: jamison.bartz at compaq.com 

-----Original Message-----
From: Kevin [mailto:speakerconnection at home.com]
Sent: Monday, July 26, 1999 10:25 AM
To: gmecm at efi332.eng.ohio-state.edu
Subject: 3800 series II swap in Lesabre T-type



Hey all, hope everyone is well..

The reason I am now writing is to thank everyone for the advice on the
injector cleaning. After getting them to stop leak.. the idle has really
improoved a lot. They were pretty off balance.

A day after getting it all right.... I blew my tranny... 2nd and 3rd slip
pretty bad on my T4-440.  I am looking at putting in a 4T-60E and have seen
that these trannies are still used today in the monte carlo and lumina's..
does anyone know which one would have a 3.06 final drive ratio?

My other option I have been very slightly thinking about, is using a 5spd
from a 94 Z-24... are there any thoughts on this..?? would there be problems
with code in the eprom? am I making too much of a headache in work ? I know
I need a clutch.... pedal, master cylinder... has this ever been done
before?   Any response is greatly appreciated.. hope to hear from you all
soon.

Yours Truly,

Kevin