It runs now! (pulls liike a beast too)

[TK]

I run 800mV on the lowest reading of 3 O2 sensors. They can vary 100mV from
each other with the same chip. I take the one that reads the lowest on WOT
runs and keep it at 800mV minimum.

That seems to be what others go with unless they can afford pistons.

Terry Kelley

-----Original Message-----
From: Todd....!! <atc347 at c-com.net>
To: gmecm at efi332.eng.ohio-state.edu <gmecm at efi332.eng.ohio-state.edu>
Date: Saturday, June 19, 1999 11:07 PM
Subject: Re: It runs now! (pulls liike a beast too)


>Hey Christer,
>
>Sounds like you got a plan man!
>
>Sounds like a good logically based decision as well...
>
>Your input is guiding a few others' decisions as well, I'm sure....
>
>ALSO, quick question focusing on the o2 readings you've stated....
>
>I assume that your o2 reading for acceleration is what you progarmmed it
>to be? 780?  Due to that being what you've programmed it to be....
>Correct?  (That's the first question)
>
>Second question is what are your cruising parameters for your o2
>reading?
>
>If not 800, then what 780? or 750? or 600?  What's the leannest we
>should EVER go with our a/f mixture?
>
>Thanks for the tutorial?
>
>LATER!,
>
>Todd....!!
>
>---------------------
>
>
>
>
>
>christer.medin at lennoxintl.com wrote:
>>
>> Actually, this IS the Haltech ride, and it ain't mine :^) Good friend's
car we've been working on for a while... thanks for the information on the
rotor phasing, I'm sure we can sort it out and be able to get 38 degrees of
advance finally.
>> After seeing how well the Haltech worked on his car, and how tunable it
is, I'm getting one for my project car once I decide what I want :^)  VERY
good software, tons of parameters to tweak... and the car is _strong_.  Now
we're working on leaning it out a bit at cruise, because he only got 5 mpg
going to work yesterday, hehe ;^)  O2s were in the mid-high 800s at cruise
(around 780 when getting on it), so we're leaning it out to get them down a
bit.  Car's got 3.42 rear and an overdrive tranny,
>>
>> Christer
>>
>> ----------
>> From:   MIME :atc347 at c-com.net
>> Sent:   Friday, June 18, 1999 11:45 AM
>> To:     gmecm at efi332.eng.ohio-state.edu
>> Subject:        Re: It runs now! (pulls liike a beast too)
>> [...]
>>
>> Other than this lil stumble, sounds like you have one cool injected ride
>> on hour hands!!  Keep it up!
>>
>> So, you're thinkin of a haltech, ey?
>>
>> Keep us informed of that project as well, if you please?
>>
>> Later!
>>
>> Todd....!!
>> http://www.c-com.net/~atc347/toddlnk.htm
>> --------------
>
>
>