CAGS?????

[DAVE_HEMPSTEAD at HP-Andover-om3.om.hp.com]

From: steve ravet <steve.ravet at arm.com>
Date: Thu, 18 Mar 1999 11:30:25 +0000
Subject: Re: DTC check xmission light

I wasn't paying attention to the beginning of the thread so I don't know
if this is appropriate...  Later 6 speed F bodies and vettes expect to
see a load where the CAGS solenoid is.  Just disconnecting it sets a
code, you have to put in a resistor.  Is that what y'all are talking
about?

- --steve

DAVE_HEMPSTEAD at HP-Andover-om3.om.hp.com wrote:
> 
> Thanks for the suggestions for both this DTC and where to find a computer.
> 
> I have the MIL light hooked up.  I'll go check which pin on which connector it
> goes to.  Before I hooked this light up, I got another DTC that indicated that
> the MIL was open.
> 
> This DTC implies that there is a separate 'Check Transmission' light on the
> dash, that I need to wire up a dummy resistor to.
> 
> Dave Hempstead

Steve,
   What is the CAGS solenoid????   That could be it. 

Thanks for the hint,
Dave Hempstead