Speed limiter & new pennies

[Programmer]

Ahhhh....Thank you.  Makes perfect sense now-- I'm now assimilated.

-----Original Message-----
From: David Cooley <n5xmt at bellsouth.net>
To: gmecm at efi332.eng.ohio-state.edu <gmecm at efi332.eng.ohio-state.edu>
Date: November 19, 1999 11:37 AM
Subject: Re: Speed limiter & new pennies


>At 11:24 AM 11/19/1999 -0700, you wrote:
>
>>Guess I thought I asked a pretty clear question. I know how to edit the
>>eprom parameters--I just don't understand how the following "commands" are
>>entered.
>>
>>D35A                      37 START:
>>    D35A C6 4B                38  LDAB #75  ; cut-out mph
>>    D35C 96 04                39  LDAA *$$04  ; status
>>    D35E 85 40                40  BITA #$$40  ; 1 == fuel on in effect
>>    D360 26 02                41  BNE RICH0  ; bra if rich, fuel on
>>    D362 C6 4A                42  LDAB #74  ; mph for fuel back on
>>    D364                      43 RICH0:
>
>The table on the left is the eprom address followed by the data in that
>address.
>IE: location D35A contains the hex values C6 4B.  Those numbers mean: LDAB
#75
>This is basically the output of a disassembler... real numerical values on
>the left, what code/command they stand for on the right...
>the line: D35A    37 START:
>just means that the subroutine starts at D35A
>37 is the line number (IE: this listing had 36 lines of data above it for
>something else).
>
>===========================================================
>David Cooley N5XMT Internet: N5XMT at bellsouth.net
>Packet: N5XMT at KQ4LO.#INT.NC.USA.NA T.A.P.R. Member #7068
>We are Borg... Prepare to be assimilated!
>===========================================================
>