SBC intake center bolt holes

[KasaRyan at aol.com]

Ok folks - lets say you wanted to do some mix and match with heads and 
manifolds on small block chevy's and are too cheap to spend 150 bucks on the 
right manifold, or 400 on heads.  How do you make them go together - what 
have people actually had luck with.

Option 1 - B&M - now holley - used to sell some aluminum shims and long bolts 
to make up for the angle difference.  Supposedly you just reversed the shims 
depending on which way you wanted to go (and probably hogged out the manifold 
holes) - has anyone used these, know cost or PN?

Option 2 - epoxy the holes in the heads and have a machine shop put in new 
ones at the proper angle - how much?

Option 3 epoxy all the holes and goober everything up with RTV silicone (big 
chance for leaks)

What works, what have you done, etc. - someone on the howell list was asking 
the same questions - specifically to put a tbi man on an older engine.  I 
would be more interested in going the other way - tbi heads with old manifold.

Thanks for listening to my electroyappin!
Ryan Hampl - a K-State Grad!    kasaryan at aol.com
139 Hoover Ct.                  Controls Engineer (tubes rule!)  
Salina, KS  67401               97 B12 / 86 V65 / 93chevy truck EFI 383
phone  (785) 825 5831           I'M ALWAYS FIRST TO THE GROCERY STORE!
----------------------------------------------------------------------------
To unsubscribe from gmecm, send "unsubscribe gmecm" (without the quotes)
in the body of a message (not the subject) to majordomo at lists.diy-efi.org