Syncing crossfire injection

[Bruce Plecan]

  I usually can get by with just setting them mechanically, with just 14" wide strips of notebook paper.  If you want to use a piece of 1/4" hose you can listen down by the butterfly for how much noise there is and do it that way.
    Close is good enough, if too critical, then probably a calibration problem.
    Remember to have IACs disconnected.  Do test a min idle speed.
  Grumpy


  I want to check the synchronization of my crossfire injection, but don't have a manometer.
  Is a map sensor connected to a DVM sensitive enough to use for this?
  Any other ideas?
  Kevin R
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.diy-efi.org/pipermail/gmecm/attachments/20000117/2e5b5d10/attachment.html>